Why is there a pressure difference in Roxell SparkCup filter?
If you notice a difference between the incoming and outgoing pressure in the filter of your Roxell Farm Equipment, it indicates contamination of the filter set. Regularly replace the filter cartridge and use clear water to prevent this.
Why do connectors get loose on Roxell SparkCup?
Connectors on your Roxell Farm Equipment might get loose due to several reasons. Too much water pressure on the line can cause this; open the end valve before flushing, ensuring maximum water pressure does not exceed 3 BAR. Incorrect rinsing procedures can also lead to this; see instructions page 10 till 15. A broken clamping strip should be replaced. Finally, a bad glue connection requires a new glue connection using the prescribed glue.
Why is the suspension cord loose on my Roxell SparkCup Farm Equipment?
If the suspension cord on your Roxell Farm Equipment is loose, it indicates an incorrect fixing of the three-hole string adjuster or adjusting plate. Install the three-hole string adjuster clamp correctly and check the other suspension points.
What causes leaking connectors in Roxell SparkCup?
If you're experiencing leaking connectors in your Roxell Farm Equipment, it's likely due to incorrect installation. Ensure you are using the correct tools for installation.
What causes deformed suspensions in Roxell SparkCup?
If you notice deformed suspensions in your Roxell Farm Equipment, it could be because the cable is stretched too much. Adjust the stretch on the cable to resolve this. Also, check for birds perching on the line, and refer to the actions for addressing birds perching on the system.
Why does the line sag at the pressure regulator in Roxell SparkCup Farm Equipment?
If you find that the line sags at the pressure regulator in your Roxell Farm Equipment, it indicates an incorrect height adjustment. Ensure the pressure regulator is well-aligned with the rest of the line.
Why is there insufficient water supply in Roxell SparkCup?
If you're experiencing insufficient water supply in the house with your Roxell Farm Equipment, it could be due to low water pressure. Check the pump to ensure it's functioning correctly. Additionally, the diameter of the supply tube might be too small; install supply pipes of at least 25 mm diameter.
Why does the line sag in Roxell Farm Equipment?
If the line in your Roxell Farm Equipment sags, it's likely due to individual suspension points being at an incorrect height. Ensure you suspend the line horizontally to correct this.
Why is water consumption low when starting layers with Roxell Farm Equipment?
If you're experiencing insufficient water consumption with your Roxell Farm Equipment when starting up layers (production) at 16-18 weeks, consider that the birds may have been reared on another system. Try providing a longer period with light (24 hours). Also, ensure there's enough adaptation time by maximizing light intensity, putting some water into the cups, and temporarily lowering the water pressure to 0.3 bar.
Why are all the cups running over in my Roxell Farm Equipment?
If all cups in your Roxell Farm Equipment system are running over, it could be due to a couple of reasons. First, check if the pressure regulator is set too low, especially if you're using float balls; if so, increase the pressure. Also, ensure that the end valve is completely closed.
Compliance with legal regulations and safety rules for assembly and operation.
Defines intended use, misuse, and manufacturer liability for product damage.
Specifies user and technician qualifications for product operation and maintenance.
Guidelines for storing, transporting, and environmentally disposing of system components.
WEEE disposal, waste handling for EU customers, and noise emission limits.
Procedure for safely de-energizing equipment before maintenance or repair.
Requirements for PPE and minimum illuminance levels for safe operation.
Precautions for electrical components, control panels, and drive units.
Explanation of danger levels (DANGER, WARNING, CAUTION) and safety symbols.
Table of maximum allowable concentrations for various water parameters.
Impact of phosphates, nitrates, and algae on water systems and animal health.
Impact of iron in water on system, health, and medication effectiveness.
Effects of water hardness and calcium deposits on the system and consumption.
How certain medications can affect water lines and cause deposits or growth.
Methods for cleaning inorganic and organic deposits using specific agents.
Steps for setting up water pressure, flushing lines, and installing components.
Adjusting water levels and lines for different bird ages and types.
Recommended bird density per cup and climate considerations for operation.
Step-by-step instructions for operating the drinking system during the flock.
Instructions and diagrams for disassembling small Sparkcup cups.
Instructions and diagrams for disassembling medium and big Sparkcup cups.
Steps for replacing valves, including sealing and cup reassembly.
Test procedure to verify if water supply meets system requirements.
Using satellite drinkers for starting up chicks and their installation process.
Critical safety instructions for operating the hand winch system.
Common problems and corrective actions for hand winch operation.
Procedures for cleaning and maintaining the hand winch system.
General| Brand | Roxell |
|---|---|
| Model | SparkCup |
| Category | Farm Equipment |
| Language | English |
To Next Page
