Why Royal Sovereign Laminator motor does not work?
If the motor of your Royal Sovereign Laminator isn't working, first check if the machine is plugged in and if the power button is turned on.
What to do if Royal Sovereign APL-330U rollers are moving but the item is not?
If the rollers of your Royal Sovereign Laminator are moving but the item isn't, hold the reverse button until the pouch exits the front. You can then try laminating again after 15 seconds.
Ideal for laminating photos, documents, and digital prints without a carrier.
Suitable for heat-sensitive prints.
Precise temperature control using Digital Micom.
Motor reverses automatically when a jam occurs.
Prevent fire or injury by keeping foreign articles out of the machine.
Do not laminate items exceeding the recommended material thickness.
Insert pouch film with the sealed end first to prevent jamming.
Do not immerse the laminator in water or permit liquids inside.
Close supervision is required when used near children.
Do not cut pouch before inserting; this can cause jamming.
Operate only for intended use; do not laminate leaves, flowers, clothes.
Do not operate with a damaged plug or cord; contact an electrician.
General| Model | APL-330U |
|---|---|
| Max Laminating Thickness | 5 mil |
| Warm-up Time | 5 minutes |
| Number of Rollers | 2 |
| Carrier | Yes |
| Hot and Cold Lamination | Yes |
| Laminating Width | 12 inches |
To Next Page