Need help?Do you have a question about the Royal Sovereign RSC-1651LS/LSH and is the answer not in the manual?
General| Model | RSC-1651LS/LSH |
|---|---|
| Maximum Lamination Thickness | 10 mil |
| Speed | Up to 20 feet per minute (6.1 m/min) |
| Roller Type | Silicone |
| Power Consumption | 120V, 60Hz, 1.5A |
| Max. Laminating Thickness | 10 mil |
| Take-up Reel | Yes |
| Warm-Up Time | N/A (Cold Laminator) |
| Laminating Thickness | 1.5 to 10 mil |
| Power Supply | 110-120V, 60Hz |
| Type | Cold Roll Laminator |
Troubleshooting steps for laminator rollers not heating, detailing causes like disconnected heater wire and defective T/fuse.
Troubleshooting guide for laminator rollers overheating, covering causes like improper sensor connection and defective heater assembly.
Diagnosing and resolving issues with laminator rollers not running, including checking emergency switches, laser sensor, and motor wiring.
Steps to troubleshoot and resolve a complete lack of main power to the laminator, checking fuses, wiring, and transformer.
Guide to synchronizing roller and take-up shaft speeds by adjusting a specific bolt with a wrench.
Steps for adjusting the front roller pressure using an Allen wrench and verifying tension with a push-pull scale.
Steps for installing the Front Feeder accessory, involving mounting brackets and a spindle using specific bolts.
Procedure for installing the Rear Rewinder option, covering cover removal, lever adjustments, and rewinder mounting.
Detailed wiring schematic for the RSC-1651LS and RSC-1402CW models, showing component interconnections.
Wiring schematic for the RSC-1651LSH and RSC-1402HW models, illustrating their specific electrical layouts.
To Next Page