Why are the rollers not turning on my Royal Sovereign RSC-LS Laminator?
If your Royal Sovereign Laminator has power but the rollers aren't turning after pressing the 'RUN' button, consider these possibilities: 1. Make sure the emergency switch(es) is disengaged. 2. Ensure the paper guide is correctly installed so the micro switch activates. 3. Check the motor fuse and replace it if blown.
How to fix curled lamination on a Royal Sovereign RSC-LS Laminator?
If you notice curled lamination when using your Royal Sovereign Laminator, it might be due to: * Upward curl: Loosen the top roll film tension. * Downward curl: Loosen the bottom roll film tension.
What to do if my Royal Sovereign RSC-LS Laminator is not heating up?
If your Royal Sovereign Laminator isn't heating up, make sure you have set the desired temperature. Increase the temperature setting as needed.
What to do if my Royal Sovereign Laminator will not turn on?
If your Royal Sovereign Laminator won't turn on, check these potential causes: * Ensure the power cord is properly plugged into the outlet. * Verify the power switch is in the “I” (On) position. * Check if the circuit breaker has tripped and reset it if necessary. * Inspect the main power fuse and replace it if it's blown.
General| Model | RSC-LS Series |
|---|---|
| Hot and Cold Lamination | Yes |
| Jam Release Lever | Yes |
| Laminating Width | 12 inches |
| Laminating Speed | 12 inches per minute |
| Warm-up Time | 5 minutes |
| Power Requirements | 120V, 60Hz |
To Next Page
