Cable Tester with Probe / English
EN- 9
Specifications:
Name
Cable Tester with Probe
Display
LCD Module (64 mm x 33 mm)
Connector type
RJ45, RJ12 ( RJ11 ) & F connector
Button
(1) LAN . (2) TEL . (3) COAX . (4) TONE . (5) LENGTH .(6) TEST .
(7) POWER . (8)
▲
. (9)
▼
. (10) ◄. (11) ►. (12) MEMORY. (13) SETUP.
Cable type
Shielded or unshielded, CAT -5, CAT-6, CAT-7
Error status
Open circuit, short circuit, cross circuit and split pairs
Measure types
Measures cable length via TDR
Checks and verifies wire map
Generates two different tracing tones to help identify users
Cable length
& accuracy
Accuracy of the length measurement is ± 5 % length: 1~350 meter
(3~1200 feet)
Minimum
cable length
for testing of
split pairs
1 meter (3 feet)
Power source
9 Volt battery
Detects a low battery condition.
Turns off
automatically
Auto-off in any mode and low power consumption for long battery life
Input
protection
Protection against excess voltage, transients ringer signal
Physical
Dimension
195 mm (L) , 90 mm (W) , 40 mm (H)
Environmental
Operating Temperature: 0° to 50° C ( 32° to 122° F )
Storage Temperature: -10° to 60° C (14° to 140° F ) Humidity: 10 %
to 90 % non-condensing
Accessories
F to BNC Adapter * 2 pcs, 9 Volt battery * 2 pcs, RJ45/RJ11 Adapter
Belt Clip * 1pcs, BAG * 1pcs
To Next Page
Loading...