30
5) Refit the plastic wing nut and tighten. The nut should be tight enough to
stop the rudder slopping about in the stock, but not tight enough as to
make it hard to rotate the rudder.
6) Tie the rudder downhaul block onto the rope that you threaded into the
stock (see picture 4.22).
7) Take the rudder downhaul rope and tie one end to the cleat at the front
end of the tiller.
8) Thread the other end through the rudder downhaul block and then back
through the cleat (see picture 4.23).
9) Tie a nice stopper knot in the end.
Picture 4.22 The rudder fitted in the stock.
Picture 4.23 The rudder downhaul fitted.
To Next Page
Loading...
