29
1. Tie one end of the jib sheet to the p-clip located between the jib fairlead
and jib cleat.
2. Pass the other end through the clew of the jib and back through the
fairlead and jib cleat.
3. Pass the jib sheet across the boat.
4. Repeat step 1 but in reverse this time, so going through the jib cleat
first.
Picture 4.21 Jib sheets.
4.8 The rudder.
To complete this section, you will require:
• The rudder.
• The rudder stock.
• The rudder downhaul and block.
1) Undo the plastic wing nut on the rudder stock and remove the bolt.
2) Slide the rudder into the stock making sure to feed the rope over the
small roller fitted in the stock, and out under the tiller.
3) Line up the hole in the rudder with the hole in the rudder stock.
4) Push the bolt through the stock and rudder, making sure to line up the
head of the bolt with the recess in the plastic washer. Also that the little
lugs on the plastic washer line up with the holes in the stock. It may
need a little tap to get it through!
To Next Page
Loading...
