The Daggerboard Handle
Please note comments in section 5.2 regarding water ingress in foils.
3.7 The Rudder
To complete this section, you will require:
• The rudder
• The rudder stock
• The Tiller
• The Tiller retaining screw
• The Tiller extension
1) Remove the rudder assembly from the foil pack and locate the components- the
self-tapping screw is in a small bag, in with the tiller arm.
2) Slide the Tiller into the stock and fix it with the self-tapping screw.
The Rudder Fitted in the Stock
To Next Page
Loading...
