RS Quba - Rigging the Mast

3.3 Rigging the Mast
There are currently 3 options for the mast:
Standard two piece round mast, optional one piece round mast and optional two
piece tracked mast.
To complete this section, you will need:
• The mast top section
• The mast lower section
• Alternatively: One Piece Mast
• The main halyard (tracked mast only)
• The downhaul line
• The downhaul block
To assemble the Standard Mast:
1. Join the mast by inserting the mast top section into the mast lower section.
2. Push the mast top section in until it butts up against the mast lower section.
The sail should then be sleeved onto the mast, ensuring that the eye for the jib
halyard is visible in the cut out. If you have the optional jib pack, thread the halyard
through the eye at this stage. (See section 3.9: Rigging the Jib).
If you have the Jib Pack, please refer to Section 3.9 Rigging the Jib before
stepping the mast in the boat.