Activate and Deactivate the Alarm Timer
- Press the ALARM (1 or 2) buttons repeatedly to activate or deactivate the timer.
- If the timer is activated, [AL1] or [AL2] is displayed on the front of the unit.
- If the timer is deactivated, [AL1 ] or [AL2 ] will disappear from the display on the front of the unit.
Repeat Alarm
You can press to adjust the interval to repeat alarm. When the alarm rings, press the SNOOZE/DIMMER button on main unit or the
SNOOZE button on remote control. The alarm repeats ringing 9 minutes later.
Stop Alarm Ring
When the alarm rings, press the corresponding ALARM (1 or 2) button. The alarm stops, but the alarm settings remain.
View the Alarm Settings
Press the ALARM (1 or 2) buttons to view the alarm settings.
General Operation
Standby/ON
• When you first connect the unit to the main socket, the unit will be in STANDBY mode.
• Press the ON/OFF/SOURCE button on the main unit or the
button on the remote control to switch the main unit ON.
• Press and hold the ON/OFF/SOURCE button on the main unit or press the
button on the remote control to switch the main unit back to
Standby mode.
• Disconnect the main plug from the main socket if you want to switch the unit off completely.
- If there is no signal under the Bluetooth, DOCK, LINE IN mode, the unit will automatically be switched off within 15 minutes.
Select Modes
Press the ON/OFF/SOURCE button on the main unit repeatedly or the DOCK, LINE IN and BT/FM buttons on the remote control to
select the desired mode. The selected mode will show on the display.
Adjust Display Brightness
Press the SNOOZE/DIMMER button on main unit or the DIMMER button on remote control repeatedly to select different levels of display
brightness.
Select a Preset Sound Effect
During play, press the EQ button on remote control repeatedly to select: [POP], [CLASSIC], [ROCK], [JAZZ], [FLAT].
Adjust the Volume
- During play, press the VOL+/- buttons on remote control or on main unit to increase/decrease the volume level.
- If you wish to turn the sound off, press the MUTE button on the remote control. Press the MUTE button again or press VOL +/–
buttons on remote control or on main unit to resume normal listening.
Set the Sleep Timer
This unit can switch to standby automatically after a set period of time.
1 Press the SLEEP button on remote control repeatedly to select a set period of time (in minutes).
• When the sleep timer is activated, the display will show
“”
and the volume will gradually decrease before the unit powers off.
2 Press the SLEEP button on remote control repeatedly until [OFF] is displayed.
• When the sleep timer is deactivated,
“”
disappears from the display.
LINE IN Operation
To Next Page
Loading...