RTK RE 3 52 - User Manual

3050-8010
Einbau- und Betriebsanleitung für digitale Regelgeräte der Baureihe RE 3.52 + RE 3.53
Installation and Operating instructions of the RE 3.52 + RE 3.53 series
Instructions de montage et de service les séries RE 3.52 + RE 3.53
Baureihe / Series / Séries
RE 3050
Regeltechnik Kornwestheim
GmbH
Max-Planck Straße 3
D-70806 Kornwestheim
Telefon +49 7154 / 13 14 - 0
Telefax +49 7154 / 13 14 - 31
Internet www.rtk.de
E-Mail info@rtk.de
- 1 -
Inhalt Seite
1 Wichtiger Hinweis 2
2 Allgemeine Hinweise 3
3 Montage und Anschluß 4
4 Elektrischer Anschluß 6
5 Bedienung 7
6 Kalibrieren der Stellungsrückmeldung yP: 14
7 Reglerkennwerte ( PID ) 15
8 Empirisch optimieren 17
9 Alarmverarbeitung 18
10 Programmgeber 19
11 Regleranpassung an die Regelstrecke 23
Contens Page
1 Important Information 26
2 General information 27
3 Installation and connection 28
4 Electrical connections 30
5 Operation 31
6 Calibrating the- position feedback yP: 38
7 Controller characteristics ( PID ) 39
8 Empirical optimization 41
9 Alarm configuration 42
10 Programmer 43
11 Adjusting the controller to the controlled system 47

RTK RE 3 52 Specifications

General

Brand	RTK
Model	RE 3 52
Category	Controller
Language	English

Summary

1 Important Information

2 General Information

2.2 Safety Information

Emphasizes mandatory observation of safety regulations and insulation standards.

3 Installation and Connection

3.1 Installation

Describes controller mounting, switchboard cutout, and fastening elements for IP65.

3.2 Removing the Controller from the Housing

Explains how to safely remove the controller insert from its housing for maintenance.

3.3 Installing the Controller in the Housing

Details the procedure for carefully inserting the controller into its housing and securing it.

4 Electrical Connections

5 Operation

5.1 Frontal View

5.5 Parameter and Configuration Level

5.7 Allocation of Parameters to the ‘Extended Operating Level’

6 Calibrating the Position Feedback yP

7 Controller Characteristics (PID)

7.1 Three-Point-Step Controller

7.2 Continuous Controllers

8 Empirical Optimization

9 Alarm Configuration

10 Programmer

10.1 Definition of the Programmer

10.2 Entering Parameters of the Segments

11 Adjusting the Controller to the Controlled System

11.1 Self Optimization

Explains the procedure for automatically determining optimal controller parameters.

11.4 Starting from Automatic Operation

Details the self-optimization process when starting from automatic control mode.

11.5 Starting from Manual Operation

Describes how self-optimization is initiated and performed from manual operation.

11.6 Meaning of the Optimization Messages ORes1; ORes2

Explains fault messages and possible solutions during the optimization process.