LIT000381000 Rev A Copyright Bosch Security Systems 06/2009 Pg – 1
Quick Installation Guide for Zeus III Intercom Matrix – 90007843XXX
Parts List
Included Parts
A. Zeus III unit (p/n 90007843000)
B. Power Cord*, US, 115V (2)
(p/n 550024-013)
C. USB Cable (p/n 600091)
User Manual
(p/n 93507843000)
Warranty
(p/n 38110-387)
* Power Cord, European (550024-000)
Power Cord, UK, 13A (550024-005)
Zeus III unit without power cord (90007843-300)
Zeus III unit UK (90007843-200)
Zeus III unit EURO (90007843-100)
Instructions
To power on the Zeus III unit, do the following:
1. Connect the power cord connector end to the power
module on the rear side of the Zeus III (see Detail A).
2. Connect the power cord plug to an electrical outlet.
The Zeus III starts its power up sequence. See the
Zeus III user manual for the power up sequence
description.
Note: Repeat step 1 and step 2 for redundant power
supplies.
3. Configure the Zeus III in one of four (4) ways:
A. USB (page 1)
B. Serial (page 2)
C. Network (with Standard RJ-45 cable)(page 2)
D. Network (with RJ-45 Crossover cable)
(page 3) (
Used when configuring the Zeus III for
the first time with no serial or USB port available
)
USB Configuration
Note: If you are configuring a USB connection for the first
time, you must manually navigate to the USB drivers at
C:\Telex\AZedit\USB.
1. Attach the supplied USB cable to the USB
Connector located on the front of the Zeus III.
2. Attach the other end of the USB cable to any USB
connector on the computer with AZedit loaded on it.
3. In AZedit, from the Options menu, select
Communications.
The Communications window appears.
4. Select the USB radio button.
5. Click OK.
The Zeus III is configured to connect to AZedit via
USB.
To Next Page
Need help?
General
