RTS Altus - User Manual

4
5
YES - jiggle NO - jiggle
This means limits have already been set. Press and
hold simultaneously the Up and Down button.
The product should jiggle.
After the
jiggle
proceed to
step 10.
Press and hold simultaneously the Up and Down
button. The product should jiggle.
After the jiggle
continue to
step 6.
18
Altus RTS, Orea RTS & Sonesse RTS
Programming
1
Select Channel
6
Check the correct direction of rotation
Press and hold the
Down button.
Does the product
extend?
YES - The product extends while pressing the
down button - Go to step 8
NO - The product retracts while pressing the
down button - Continue to step 7
7
To reverse the
direction of the
motor, press and
hold the Stop
button until the
product jiggles.
Press and hold
the Down
button to test
that the motor
direction is
correct.
Reverse the direction of rotation
Press for
5 secs
Continue to step 8
All Telis RTS Transmitters, Centralis RTS, Chronis RTS, Smoove.
Dry Contact Transmitters and 5 Channel RTS Transmitter (cannot be used to program).
Soliris/Eolis RTS Sensor, Sunis/Eolis 3D RTS Sensor (cannot be used to program).
If you are using a multi channel remote, select the required channel.
The channel must be selected prior to programming. Continue to step 2...
C
Switch on the power
to the motor.
Only connect one motor at a time.
2
Identify the correct motor mode
Did the product perform a jiggle?
In order to iden-
tify which mode the
motor is in, make
sure that you pay
attention to whether
the product performs
a jiggle when power
is applied.
3
Motor Mode
YES - Go to step 4
NO - Go to step 5

Summary

Altus RTS, Orea RTS & Sonesse RTS Programming

Initial Channel Selection and Motor Mode Identification

Steps to select the channel and identify the motor's operating mode.

Verifying Motor Direction and Reversing if Needed

Checking the motor's rotation direction and reversing it if incorrect.

Recording Limit Positions and Pairing Remote

Setting the upper/lower limits and programming the RTS control to the motor.

Adjusting Motor Limit Positions

Adjusting the Lower Limit Position

Procedure to set the lowest position the motor can reach.

Adjusting the Upper Limit Position

Procedure to set the highest position the motor can reach.

My Position Programming

Setting an Intermediate My Position

Programming a custom intermediate position for the motor.

Deleting an Intermediate My Position

Removing a previously set intermediate position.

Using the Intermediate My Position

Activating the programmed intermediate position.

Pair New Channels or Remotes

Prepare Motor for New Control Pairing

Setting the motor to programming mode using an existing remote.

Program New RTS Control to Motor

Assigning a new RTS control to the motor.

Removing a RTS Control from the Motor

Prepare Motor for Control Removal

Setting the motor to programming mode to remove controls.

De-Program RTS Control from Motor

Removing a specific RTS control from the motor.

Procedure to Replace a Lost or Damaged RTS Control

Perform Double Power Cut for Reset

Using timed power interruptions to reset the motor for new control pairing.

Erasing the Memory of the Motor

Erase Motor Memory via Power Cycling

Using timed power interruptions to erase all programmed remotes and limits.

RTS Altus Specifications

General

Brand	RTS
Model	Altus
Category	Intercom System
Language	English