Need help?Do you have a question about the RUD easy2go and is the answer not in the manual?
General| Brand | RUD |
|---|---|
| Model | easy2go |
| Category | Automobile Accessories |
| Language | English |
Lay out the chain neatly and pull the orange ring end (1) around the tyre, ensuring the ring (2) lies near the tyre's back.
Take both ends of the ring and pull them up around the tyre tread to begin securing the chain.
Hook the connecting pieces (3) together, then attach the orange hook (4) into the eyelet (5) on the upper wheel part.
Hook the grey hook (7) into the eyelet (8) and secure the eyelets (9) to the rubber tensioner (10).
Ensure the chain mesh is evenly spread over the outer sidewall of the tyre for optimal performance.
Consult your vehicle's manual to determine the correct axle for fitting snow chains on a 4WD.
Park the vehicle to halt the wheel with the orange hook (4) in position; unhook eyelets (9) from the tensioner (10).
Press the release button on the ratchet (6) to release the tensioning chain and pull it back.
Unhook the orange (4) and grey (7) hooks from their respective attachment points.
Pull chain mesh to the centre to open connector (3), then lay chain aside and remove the second chain.
Note the position of the orange hook (4) relative to the axle for front-wheel vs. rear-wheel drive removal.
Ensure snow chain size precisely matches the tyre size designation for safety and proper fitment.
Do not use chains worn beyond 50% due to risk of breakage; replace worn chains promptly.
Maximum permitted speed when using snow chains is 50 kph (30 mph) as per traffic regulations.
Wash chains in warm water after use and allow to dry; do not apply oil.
RUD Ketten offers repair and modification services; return chains as needed.
To Next Page
