RuggedCom RuggedSwitch RS900 Family - Console Port Wiring; Figure 8 - RS232 Female DCE Pin-Out; Table 2

To Next Page

To Previous Page

RS900 Family Installation Guide

2.3 Console Port Wiring

The RS232 port is used for configuring the unit. A straight-through serial cable with a

DB-9 connector is required. There is no need to crossover the Transmit and Receive

signals from the PC side since this has been done internally.

Figure 8 - RS232 Female DCE pin-out

Pin Signal

1 No Connection

2 Transmit Data

3 Receive Data

4 No Connection

5 Ground

6 No Connection

7 No Connection

8 No Connection

9 No Connection

Table 2 - RS232 Female DCE pin-out

NOTE: This port is not intended to be a permanent connection and the cable shall be

less than 2m (6.5 ft) in length.

 2010 RuggedCom Inc. 21 Rev107

RuggedCom RuggedSwitch RS900 Family - Console Port Wiring; Figure 8 - RS232 Female DCE Pin-Out; Table 2 - RS232 Female DCE Pin-Out