Runcobo CS20C - Wi-Fi Setup Testing and Later Configuration

5.To test your Wi-Fi configurations, close your Runcobo app, and use the scale to make a new
measurement (see Weighing without the App, page 9). When finishes, re-open your Runcobo app
again, and your new data should be already recorded in your app.
By now your app setup is complete with both Bluetooth connections and Wi-Fi connections.
6.If Wi-Fi connections were not setup initially, a user can setup it later: On the “Measurements”
screen, tap the “+” sign at the top right corner, then select “Device Management” , tap “CS20C”
image to enter the “Select Wi-Fi” screen. It is the above Step 2. Then follow instructions to complete
Steps 3 – 5 to setup Wi-Fi Connections.
20