Runva 11 XP - Contents Warning! Safety Precautions

1
Warning (Keep This Paper)
About Using/Replacing The Steel Cable For The Winch
1. Spray Lube / Grease on Winch Cable Regularly
2. Start each pull with a minimum of 5 wraps around the drum
3. Use the bottom 2 layer for max efficiency
4. Cut The Cable To The Length You Will Need (Otherwise Not Efficiency)
 4x4 Jeep Off-Road ------------------------- 50 to 90 feet
 Tow Truck -------------------------------------- 35 to 55 feet
 Car Trailer -------------------------------------- 25 to 55 feet
 Other Operation ----------------------------- Length Need + 5 feet(On Drum)
5. To Change / Replace Steel Cable / Rope:
 Clutch To “Out” (Freespool)
 Hand Pull Out Cable / Rope All The Way To The End
 Take Off The Bolt Lock On The Drum
 Take Off The Cable End
 Put In and Lock The New Cable / Rope End On The Drum
 Clutch To “In” (Engage)
 Power In By The Switch
 Roll Back The Cable / Rope In Good Order