Runxin 82602 User Manual

MODEL 82602-F79A-LCD/82602B-F79B-LCD/82604-F82A-LCD/82604B-F82B-LCD
8
F82A-LCD
1″M
1/2″M
3/8″M
2-1/2″-
8NPSM
1.05″OD
(26.7mm)
3.5
No raw water
pass valve
when
regeneration
F82B-LCD
With raw water
pass valve
when
regeneration
F82AG-LCD
1″M
1/2″M
3/8″M
2-1/2″-
8NPSM
1.05″OD
(26.7mm)
3.5
No raw water
pass valve
when
regeneration
F82BG-LCD
With raw water
pass valve
when
regeneration
Remark: M-Male, F-Female, OD: Outer Diameter
1.5. Product Install
A. Install notice
Before installation, read all those instructions completely. Then obtain
all materials and tools needed for installation.
The installation of product, pipes and circuits, should be accomplished
by professional to ensure the product can operate normally.
Perform installation according to the relative pipeline regulations and
the specification of Inlet, Outlet, Drain and Brine Line Connector.
B. Device location
① The filter or softener should be located close to drain.
② Ensure the unit is installed in enough space for operating and
maintenance.
③ Brine tank need to be close to softener.
④ The unit should be kept away the heater, and not be exposed outdoor.
Sunshine or rain will cause the system damage.
⑤ Avoid to install the system in circumstance of Acid/Alkaline, magnetic or
strong virbration, because above factors will cause the system disorder.

Runxin 82602 Specifications

General

Brand	Runxin
Model	82602
Category	Control Unit
Language	English