RUPTELA FLS Pro - Assembly and Configuration

www.ruptela.com support@ruptela.com | +370 5 2045030 5
Assembly and configuration
Drill a hole in the center of the tank.
Use a 38 mm hole saw arbor.
Insert a gasket into the measurement head.
Screw in the flange.
Insert the assembled probe into the fuel tank.
Measure the distance from the flange to the fuel
tank (MD).
Add an additional 4.5 cm to get the cutting
distance (CD).
Drill
Insert
Screw
MD
CD = MD + 4.5 cm