Guide a security seal wire through an opening on the cable connector.
Make several loops around the signal cable connector with the seal.
Guide the seal wire through the holes on the seal and tighten the seal.
Connect the FLS to the 7 m extension cable (see Appendix B).
Turn on the ignition.
Check that the required data is received before finishing the installation.
Further reading
• Documentation website: http://doc.ruptela.com
• Datasheet: https://doc.ruptela.lt/pages/viewpage.action?pageId=1442787
• User manual: https://doc.ruptela.lt/pages/viewpage.action?pageId=1442787
• RS232 converter drivers: https://doc.ruptela.lt/display/AB/Drivers+for+the+RS232-USB+Converter
• FLS configurator tool: https://doc.ruptela.lt/pages/viewpage.action?pageId=1442785
We highly recommend you read the user manual before using the device.
Legal information
Copyright © 2019 Ruptela. All rights reserved. Reproduction, transfer, distribution or storage of parts or all of the
contents in this document in any form without the prior written permission of Ruptela is prohibited. Other products
and company names mentioned in this document are trademarks or trade names of their respective owners.
To Next Page
Loading...