O&M Manual –90E1720004
Section 4 Receiving, Handling and Storage Page 12 of 52
Figure 4: Forklift Safety Strap
Cradle/Rollout
Cradles and rollouts from 100A to 2500A are shipped in their enclosure. They should be
removed and or withdrawn and inspected before energizing. See Section 8 for removing or
withdrawing the cradle or rollout.
Storage
If the Russelectric bypass-isolation transfer switch is to be stored before being placed into
service, perform the steps listed below.
1. Unpack the equipment to check for completeness and condition.
2. Reseal the equipment in its packing for protection until installation.
When storing the equipment:
1. Keep the equipment in a clean, dry place that is free from corrosive elements and
mechanical abuse.
NOTE: Indoor equipment should be stored in an atmospherically controlled building until
installation. Keep the equipment clean and dry, with a humidity less than 80% and temperature
between 32 °F (0 °C) and 104 °F (40 °C). Avoid moisture, changes in temperature, cement dust,
and corrosive atmospheres.
2. Covering the equipment with a tarpaulin may be necessary to protect it from
contaminants or moisture.
3. Do not store indoor units outdoors.
4. If it is necessary to store the equipment outdoors, make special arrangements to
keep the equipment clean, dry, and within the temperature and humidity limits
stated above.
It may be necessary to cover the equipment and install temporary heating
units.
To Next Page
Loading...
Need help?
General
