PREPARING YOUR RUSSELL HOBBS ESPRESSO MACHINE BEFORE USE:
NOTE: The numbers in the brackets below refers to the diagrams on the succeeding
pages
1. Place the unit on a flat, level surface.
2. Ensure the drip tray and grill are in place
3. Fill the espresso machine with water. There are two ways in which this can be
done:
a. Simply lift the lid of the water reservoir at the top of the espresso machine
(1) and by using a jug, fill with fresh cold water or filtered water (2).
b. Alternatively, the water reservoir can be removed and filled with fresh cold
water. To do so, lift the lid and by using the reservoir as a handle, simply
slide it out (3). Then fill with fresh cold water or filtered water (4). Replace
the water reservoir firmly and close the lid (5).
Warming plate: pre-warms
up to 9 espresso cups
Removable drip tray and grill
Designed with no dirt traps for
small coffee granules, milk or
any other spills. You can simply
wipe clean all surfaces. The drip
tray and grill can be completely
removed for easy cleaning
1.6L water reservoir
Removable water reservoir for
easy filling, simply lift it
upwards.
Operating dial: Turn to the right
for espresso or to the left for
steam or hot water
Extra cup height clearance
Additional clearance between the
filter handle and the drip tray is
designed to suit taller cups
Non-slip rubber feet
Makes the unit sturdy, preventing
it from slipping or scratching the
bench top
To Next Page
Loading...
