• Fill the water reservoir (1) (2) (3)(4) (5) with cold water and start
the appliance (6).
• Put the filter handle and an empty filter in place (7) (8) (9) and
place cups underneath the filter handle.
• When the machine is ready, the orange ‘Warm Up’ light goes off, turn the
operating dial to setting (11).
• When the cups are full of hot water, return the operating dial to
the O ‘off’ position .
NOTE: Once the appliance has been on for a while, coffee cups can be
warmed by placing them upside down on the cup warming
plate (12).
Preparing an espresso:
• Insert the power cord into a 230-240V AC power outlet and turn
the power on.
• Fill the water reservoir (1)(2)(3)(4)(5) with cold water.
• Start the unit (6). The red ‘Power” light and orange ‘Warm Up’
light will both illuminate.
• Pre-heat your coffee cups by placing them upside down on the cup warming
plate (12).
• Select the required filter (7) for 1 or 2 cups of coffee and place in the filter
handle.
• Using the measuring spoon supplied place one or two measures of ground
coffee into the filter (13). With the other end of the measuring spoon, use the
tamper to push (pack) down the ground coffee (14). Do not apply too much
pressure.
Important: Be sure not to over-fill the filter with too much coffee and wipe
around the edge of the filter to remove any ground coffee (15).
To Next Page
Loading...
