7
CARPET WASHER ASSEMBLY
Assembling Your Carpet Washer
Note: Do not plug the power cord into an electrical outlet until the
machine is fully assembled.
You will need a cross-head screwdriver
1. Carefully unpack all components and set aside the packaging.
2. Ensure the carpet washer is in the upright position.
3. Place the handle onto the base unit with the trigger facing
backwards. [Fig. 1]
4. Once the handle is in place, secure the handle to the base unit
with the two screws supplied using a cross-head screwdriver. [Fig. 2]
Caution: Do not over tighten the screws. Do not operate the
vacuum without the handle screws in place.
If you can see any damage do not use the carpet washer and
contact Customer Services.
Fig. 2Fig. 1
To Next Page
Loading...
