Russell Hobbs RHRV200 R-VAC PET - Page 13

13
SPACE ISOLATOR: BATTERY INSTALLATION & REPLACEMENT
1. OpenthecoveronthebaseoftheSpaceIsolator.
2. InsertAAbatteries(notincluded)withcorrectpolarity(+/-).
3. Replace the cover on the base of the Space Isolator.
IMPORTANT: Remove the batteries if the Space Isolator will not be used for an extended period
of time.
If your Space Isolator isn’t operating correctly, it may be necessary to re-synchronise it with
the R-Vac Pet using the following steps:
1. Firstly,turnthepowerswitchonthesideoftheR-VacPetOFF.
2. After this, switch the Space Isolator on (the power indicator on the Space Isolator should
illuminate&begintoash).
3. Using a paperclip, or similar, press in the internal synchronise button (below space isolator
power switch), and keep it pressed in.
4. NowturnthepowerswitchonthesideoftheR-VacPettoON.
5. Release the internal synchronise button after the R-Vac Pet has emitted a series of beeps,
indicating it has synchronised.
NOTE: If you fail to hear any beeping during synchronisation, repeat the above process.
Positioning your Space Isolator
The Space Isolator creates an invisible line which acts as a barrier that your vacuum cleaner will
not pass.
Place the Space Isolator against the wall, with the signal transmitter facing the area you would
like to act as a barrier.
Tip
: Place the space isolator against the wall, or it might be easily moved by the cleaner from
side or back of the space isolator, which would cause the machine cleans the confined area.
Space Isolator:
Tip: You should check code before using the Space Isolator; otherwise it will fail to work.
Steps of code check:
A : Turn off the cleaner, and turn on the Space Isolator (with power indicator on);
B : Keep holding the code check button on the Space Isolator;(
Tip:
the code check button
is inside the hole, you need to use auxiliary tools when hold the button
)
C : Turn on the cleaner;
D: After the cleaner toots 2 or 3 times,
2 or 3 times,
release the code check button, then the code
check set is finished successfully.
★ Note: If you fail to hear toot twice during the code check, just repeat the above process.
Signal transmitter
Power indicator light
Internal synchronise button
Power switch