Russell Hobbs RHRV200 R-VAC PET - Remote Control & Programming

10
REMOTE CONTROL & PROGRAMMING:
The Remote control is synchronised with your vacuum cleaner prior to purchase.
REMOTE CONTROL: BATTERY INSTALLATION & REPLACEMENT
1. OpenthecoveronthebackoftheRemotecontrol.
2. InsertAAAbatteries(notincluded)withcorrectpolarityasmarked(+/-).
3. Replace the cover on the back of the Remote control.
IMPORTANT: Remove the batteries if the Remote control will not be used for an extended
period of time.
If your Remote control isn’t operating correctly, it may be necessary to re-synchronise
it with the R-Vac Pet using the following steps:
1. TurnthepowerswitchonthesideoftheR-VacPettoOFF.
2. PressandholdtheOKbuttonontheremotecontrol,keepthebuttondownuntil
step4isconrmed.
3. TurnthepowerswitchonthesideofthevacuumtoON.
4. ReleasetheOKbuttonaftertheR-VacPethasemittedaseriesofbeeps,indicating
it has synchronised.
NOTE: If you fail to hear the beeps while synchronising, repeat the above process.
TIMER