Russell Hobbs RHRV200 R-VAC PET - Page 9

9
UV lamp (located on the under side of the vacuum)
The UV lamp will illuminate blue and automatically operate once the R-Vac Pet starts vacuuming.
As the R-Vac Pet vacuums, the UV lamp pans over the surface, sterilising and disinfecting the
oorandkillingbacteria.WipethelensoftheUVlampcleanaftereachusewithasoftcloth.
CAUTION: DonotlookdirectlyattheUVlightsource.
The following function buttons (AUTO, SPOT & CHARGE) are located on the control panel
on top of the R-Vac Pet and will only operate when the R-Vac Pet is not located on the
charging station. Use the remote control to start the R-Vac Pet from the charging station.
AUTO button (Automatic cleaning)
IMPORTANT: Before using your vacuum, clear any clutter or loose cords in the area you intend
to clean.
TheAUTObuttonisthemainmethodmostpeopleusetostarttheirR-VacPet.
PresstheAUTObuttontolettheR-VacPetstartcleaning.
OncetheR-VacPetstarts,itusesanalgorithmtoworkthroughtheroomwithaseriesofpatterns
(aseriesofzig-zags,increasingspiralsandedgefollowing)tomaximisecoverage.Duringthis
time, the R-Vac Pet can cover areas more than once - don’t be concerned by this, it is part of the
normal cleaning process.
Press any button on the control panel to stop the vacuum cleaning.
SPOT button (Spot cleaning)
TheSPOTbuttonisidealforcleaningupsmallspills(drysubstancesonly).
PressingtheSPOTbuttonwillautomaticallycleananareaofapproximately1squaremeter.The
vacuum will operate in spiral mode for 3 minutes and then switch itself off.
NOTE: To stop the vacuum when in spot cleaning mode, press any button on the control panel.
CHARGE button
IMPORTANT: Ensure you have the Charging Station set up.
Press the CHARGE button and the vacuum will automatically stop the vacuum motor (to preserve
power) and search for the charging station. This is achieved by methodically working through the
cleaning area and periodically stopping to search for the charging station.
If the charging station is detected, the vacuum will then make its way to the charging station,
dock automatically and begin to charge.
OnceonchargethePowerindicatorlightwillilluminateandash.