Russell Hobbs RHRV200 R-VAC PET - Battery Installation and Replacement

6
BATTERY INSTALLATION AND REPLACEMENT
Installing and replacing the rechargeable battery:
1. Placetheroboticvacuumcleanerupsidedownonaatstablesurface.
2. Using the screwdriver provided, remove the screws on the battery cover. (Refer to Figure 1)
3. Lift the battery cover away from the unit.
4. Attach the connector on the battery with the connector in the battery compartment by
pushingthemtogetheruntiltheyclickintoplaceandarermlysecured.(RefertoFigure2)
IMPORTANT:Theconnectorswillonlyttogetheroneway.Donottrytoforcethemtogetherif
they are not correctly aligned.
5. Hold the battery by the material tabs and lower it into the battery compartment while
guiding the cables and connectors into the cavity provided in the bottom of the battery
compartment.
6. Replace the battery cover and screws.
7. Return the vacuum to its upright position.
8. Place the vacuum on charge, there are 2 charging options:
a. Usingtheadapteronly-pluggeddirectlyintotheDCsocket(locatednexttotheON/OFF
switch), or
b. With the adapter connected to the charging station and plugged into a wall
power outlet, place the vacuum onto the charging station.
NOTE:ThevacuumwillchargewhenthePowerswitchisintheONor OFF
position.
NOTE:Thepowerindicatorwillashwhenthevacuumischarging.
c. Allowthevacuumtochargeforatleast12-14hoursbeforerstuse,orifit
has not been used for an extended period of time.
d. After charging for at least 12-14 hours, your vacuum is ready for use.
e. Whenthevacuumisfullycharged,thepowerindicatorlightwillstopashing,andwill
remainilluminated.Fortherstcharge,ifthisoccurspriorto12-14hoursofcharging,
ignore the light and leave the vacuum on charge.
QUICK START GUIDE
While the R-Vac Pet is a complex product, we have committed to making the operation as
user friendly as possible. As a result of this, you can have your R-Vac Pet working for you by
following our 3 quick steps.
1. Install R-Vac Pet’s rechargeable battery (page 6)
2. Charge your R-Vac Pet (page 8)
3. Press the AUTO button to have your home vacuumed for you (page 9)
OnceyourR-VacPethasvacuumedyourhome,itisimportanttogiveitalittleattention.
Please spend approximately 5 minutes after each cycle cleaning your R-Vac Pet. By giving
your R-Vac Pet this attention it will save you hours of vacuuming each week as well as
providing you with a more thorough clean. Please refer to the cleaning instructions on page 15.