Russell Hobbs RHRV200 R-VAC PET - Trouble Shooting

18
REMOVING, REPLACING AND CLEANING UNDER THE SIDE BRUSH:
1. Using a screw driver, release the screw in the main shaft of the side brush. (see Figure 4)
2. Remove the side brush and clean the cavity with the dust cleaning brush.
3. Placethesidebrushbackintopositionandretthescrew.
Rubber cleaning head
TROUBLE SHOOTING: Error codes will appear on the remote control
ERROR
CODE
ERROR CAUSE HOW TO SOLVE
E001
Ground detection
sensors
Clean the sensors underneath of the vacuum,
at the front
E002
Middle brush Cleanbothbrushesaspersection“CLEANING
THEMAINBRUSHANDFLOORBRUSH”
E003
Power off Charge vacuum until fully charged, then use again
E004
Left & Right wheel Check the left and right wheels and clean any dust
or hair build-up.
E005
Dustbincontact Check the dust bin and ensure it is securely
in place. Clean the dust bin contacts
FF60
Incorrect key sequence
when programming
Clear code from the remote by pressing ‘Set’, ‘Stop’
and ‘Set’ again. Ensure remote is out of programming
modebefore(ie.nothingisashingonscreen).
If the errors above have been checked and the vacuum is still not functioning correctly,
please contact customer service for advice. Do not disassemble the unit.
REMOVING, REPLACING AND CLEANING THE FRONT WHEEL:
1. Removetheentirefrontwheelassembly:usingaatheadscrewdriver,from the front of
the unit, position the screw driver down and under the front wheel assembly. Pop the wheel
assembly out using the screw driver and clean the cavity.
2. Removethewheel:usingaatheadscrewdriver,positionthescrewdriverdownandunder
the front wheel. Pop the wheel of the assembly out using the screw driver and clean the
cavityandtheaxle.Retthewheel.
Figure 4