EasyManua.ls Logo

Russell Hobbs RHRV200 R-VAC PET - Page 8

Russell Hobbs RHRV200 R-VAC PET
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
CHARGING YOUR R-Vac Pet
Manual charge:
1. Manually place the vacuum on charge - there are 2 manual charging options:
a. Usingtheadapteronly,pluggeddirectlyintotheDCsocket(locatednexttotheON/OFF
switch), or
b. With the adapter connected to the charging station, place vacuum onto the charging
station.
NOTE:ThevacuumwillchargewhenthePowerswitchisintheONor OFFposition.
NOTE:Thepowerindicatorlightwillashwhenthevacuumischarging.
2. Chargeforatleast12-14hoursbeforerstuse,orifthevacuumhasnotbeenusedforan
extended period of time.
3. Whenthevacuumisfullycharged,thepowerindicatorlightwillstopashingandwillremain
illuminated.Fortherstcharge,ifthisoccurspriorto12-14hoursofcharging,ignorethe
light and leave the vacuum on charge.
Automatic charge:
When the battery power is at a low level, the vacuum will emit a series of beeps then
automatically stop the vacuum motor (to preserve energy) and search for the charging station.
The Charge button will illuminate while it is searching.
If the charging station is detected, the vacuum will then make its way to the charging station,
dockautomaticallyandbegintocharge.Onceonchargethepowerindicatorlightwillilluminate
andash.
If the charging station is not set up the vacuum will continue searching until the battery runs out
completely.
FUNCTIONS
Power switch (located on the side of the vacuum):
The power switch is designed to isolate your battery to maximise the effective life. When not
using/chargingyourvacuumforanextendedtimeyoushouldsetthepowerswitchtotheOFF
position.
TouseyourR-VacPet,switchthePowerswitchtoONandthevacuumwillgointostandby
mode.
ThePowerindicatorlightwillilluminateandashifthebatteryisnotfull.
Tips:
• The power indicator light will illuminate when the vacuum is in operation.
• Thepowerindicatorlightwillashwhenthevacuumischarging.
• Whenthevacuumisfullycharged,thepowerindicatorlightwillstopashing,andwill
remain illuminated.

Related product manuals