Water Hardness & Setting the Salt
It is recommended that adjustments should be made in accordance with the following scheme:
*factory setting
Note: Contact your local water board for information on the hardness of your water supply.
Loading the salt into the container
Important Note:
• Only use salt specifically designed for use in dishwashers. Every other type of salt not
specifically designed for use in a dishwasher, especially table salt, will damage the water
softener. In case of damage caused by the use of unsuitable salt the manufacturer do not give
any warranty and we are not liable for any damage caused.
• Only fill with salt just before starting one of the complete washing programs.
• This will prevent any grains of salt or salty water, which may have been spilled, remaining on
the bottom of the machine for any period of time, which may cause corrosion.
The salt container is located beneath the basket and should be filled as explained in the
following section:
1. Remove the basket and then unscrew and remove the cap from the salt container. See
diagram 1 on the following page.
2. Place the salt funnel that is provided into the hole and pour approximately 1.0kg of
dishwasher salt into the salt container
3. Fully fill the salt container with water. It is normal for a small amount of water to come out of
the salt container. See diagram 2 on the following page.
4. After filling the container, screw the cap tightly back clockwise.
5. Usually, the salt warning indicator light will stop being illuminated within 2-6 days after the
salt container has been filled.
13
Softener level Setting on the water softener Water Hardness (Clarke)
H1
1
0-5
H2 2 6-11
H3
3
12-17
H4
4*
18-22
H5
5
23-34
H6
6
35-55
To Next Page
Loading...
Need help?
General
Weight and Dimensions
