5
Water and Electrical Connection
Important note: Connection to the water and electricity supplies should only be performed by
a qualified technician.
Electrical Connection
Before inserting the plug into the electrical socket, make sure that:
• The socket is earthed and complies with current regulations;
• The socket can withstand the maximum load of the appliance, which is indicated on the
appliance’s rating
• The power supply voltage falls within appliance’s rating
• The socket is compatible with the plug of the appliance. If this is not the case, ask an
authorised technician to replace the plug
• Do not use extension cables or multiple sockets.
• Once the appliance has been installed, the power supply cable and the electrical socket
should be easily accessible.
• The cable should not be bent or compressed.
Important notes:
• If the power supply cable is damaged, it must be replaced by the manufacturer or its
Technical Assistance Service in order to prevent all potential hazards.
• This appliance must be earthed.
• Your appliance comes fitted with a plug and a 13A fuse. If you need to replace the fuse,
only those rated at 13A and ASTA approved to BS1362 should be used. Correct
replacement is identified by colour coding or the marking on base of plug.
• DO NOT use the plug unless the fuse cover is fitted.
Water connection
• The dishwasher should not stand on top of the water hoses or the electricity supply cable.
• If the inlet hose is not long enough, contact a specialist store or an authorised technician
• The hose should not be bent or compressed.
• The appliance must be connected to the water supply network using new hoses. Do not use
old hoses.
• Ensure that the new hose supplied is connected and the old hose is disposed of safely.
• DO NOT overtighten the hose connector, hand tight is sufficient.
• Ensure the fill hose is not kinked.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
