27
Washing Cycles
1. Press the Time Delay button and set the required delay start time (this will be shown by time
delay the indicator lights).
2. Press the start button, the unit will start the programme at the assigned time automatically.
Adding a dish during a cycle
If you have forgotten to load a dish then it can be added at any time before the detergent is
dispensed. Please follow the below steps when adding a forgotten dish:
1. Open the door slightly to stop the washing.
2. After the spray arms stop working, you can open the door completely.
3. Load the forgotten dish or dishes.
4. Close the door, the dishwasher will start running again after 10 seconds.
Note: It is dangerous to open the door when washing, because the hot water may scald you.
At the end of the wash cycle
When a program has finished, the buzzer of the dishwasher will sound for 8 seconds, after this
duration it will stop. Turn off the appliance using the ON/OFF button and open the door of the
dishwasher. Turn off the water tap if necessary
Note: The appliance will switch off automatically 30 minutes after the program has finished.
Open the door carefully
Hot dishes are sensitive to knocks. The dishes therefore must be allowed to cool down for
approximately 15 minutes before removing from the appliance. Open the dishwasher's door,
leave it ajar and wait approximately 15 minutes before removing the dishes. In this way they will
be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside. It is recommend to wait for the drying cycle (if the
program that has been selected has this) to finish and for the dishes/crockery to cool before
removing them.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
