Russell Hobbs RHTTDW6W User Manual

Maintenance & Cleaning
1. Cut off the electrical power to the dishwasher.
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain the water from the inlet pipe and water valve. (Use a bowl to catch the water)
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a sponge to soak up water in the sump
Cleaning the Spray Arms
It is necessary to clean the spray arm regularly for hard water chemicals, as these will clog the
spray arm jets and bearings.
Wash the arm in warm soapy water and use a soft cleaning brush to clean the jets. Replace it
after rinsing them thoroughly in clean water
How to Keep your Dishwasher in the Correct Condition
After Every Wash
After every wash, turn off the water supply to the appliance and leave the door slightly open so
that moisture and odours are not trapped inside.
Remove the Plug from the socket
Before cleaning or performing maintenance, always remove the plug from the socket.
.
36
To remove the spray arm, pull the spray arm
upward.
Spray arm
Pull

Russell Hobbs RHTTDW6W Specifications

General

Door color	White
Control type	Buttons
Product size	Compact
Built-in display	Yes
Custom panel-ready	-
Appliance placement	Freestanding
Cycle time	230 min
Noise level	49 dB
Delay start (max)	24 h
Dishwashing programs	Eco, Glass/delicate, Intensive, Quick, Universal
Number of place settings	6 place settings
Number of washing programs	6
Maximum water flow pressure	1000 kPa
Minimum water flow pressure	40 kPa
Cycle time (quick washing program)	30 min
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Water consumption per cycle	6.5 L
Energy consumption per cycle	0.613 kWh

Weight and Dimensions

Depth	500 mm
Width	550 mm
Height	438 mm