RUTHMANN ECOLINE RS200 - Restart the Machine

USE AND MAINTENANCE MANUAL R68090150
ORIGINALE
RUTHMANN ITALIA S.r.l. Via Santa Maria del Piano di sotto,91/B – 47854 Montescudo-Monte Colombo (RN) - ITALIA
pag. 56
!
WARNING
ATTENTION: CARRY OUT THE CORRECTION OF THE BASKET LEVELLING WITH CARE AND
WITHOUT MATERIAL IN THE BASKET.
!
WARNING
ATTENTION: IT IS OBLIGATORY TO LEVEL THE BASKET BEFORE TO USE THE PLATFORM.
!
WARNING
ATTENTION: NOT MOVE ANY BOOMS IF THE BASKET IS NOT WELL LEVELLED; THIS COULD
CAUSE DAMEGES ON LEVELLING CYLINDERS.
8.9. RESTART THE MACHINE
Before starting the machine after a long inactive period, it is necessary to do a careful check of the main
machine members and of all safety devices to make sure they all are working perfectly.
1.
check the battery
2.
check all levels (oil, water, fuel)
3.
check the tightening of the fastening screws of the main members
4.
check if there are some liquid leaks
5.
check and replace damaged or worn parts
6.
lubricate all greasing parts
7.
check the hydraulic tube conditions
8.
check the efficiency of all safety devices
9.
check the working of all controls and pilot lights
10.
do the necessary maintenance operation
11.
do a general clearing of platform
8.10. CRITICAL ENVIRONMENTAL CONDITIONS
Cold climate (temperature lower than 5°C)
- use hydraulic oil and lubricants (they must be suited to temperature)
- make sure of the battery state
- before use, move the platform for some minutes (about 15) from the emergency control panel
(nobody must be within the basket), in order to heat the oil.
Hot climate (temperature higher than 35°C)
- use hydraulic oil and lubricants (they must be suited to temperature)
- make sure of the battery state
Dusty environments
- keep clean the rods of the cylinders and the extractable parts of the telescopic boom
- lubricate frequently the lubricators on the articulated joints
- check frequently the filters of the hydraulic system
8.11 OTHER FUNCTION FROM REMOTE CONTROL
SELECTION OF LANGUAGES: it is possible to choose the language of messages that should appear on
display. The possible languages are English (EN), Italian (IT), German (DE), French (FR) and Spanish (ES). For
selecting the languages follow this procedure:
1- Depress both push button “Display up” and “Display down” for 3 sec for
going in “MENU MODE”: