RUTHMANN Steiger TB270 - Page 220

9 Maintenance
9-34
RUTHMANN-Steiger
®
TB270
BA.GB.12-27409-05-07-FTA-jr
When using a high-pressure water cleaner the corresponding operating in-
structions of the manufacturer concerning spray pressure and spray dis-
tance must be observed.
Attention!
 Bird droppings, insects, resin and grease remains
must be washed off immediately, since they contain
substances, which can damage the painting and oth-
er plastic components considerably.
 After using the Ruthmann-Steiger for tree-pruning,
the wood shavings must be removed immediately.
E.g. at boom system, the covers of boom ends must
firstly be removed. Should an accumulation of wood
shavings be found out, authorised personnel must
carefully remove this.
 Movement spaces of moveable parts must be cleaned
immediately.
 Direct sun light must be avoided when washing the
machine.
 Do never point the water or steam stream onto the
following parts of the Ruthmann-Steiger:
 electrical components,
 electrical lines,
 hydraulic components,
 hydraulic lines,
 insulators,
 Lock caps, e.g.:
 Locking hydraulic oil tank,
 etc.,
 bearing points,
 sealing points z. B.
 door sealings,
 sealings of control boxes,
 rotary shaft seal,
 etc.,
 brake system.