BA.GB.12-27409-05-07-FTA-jr
10.2.1 Handling
Put on the supporting plates with the relieving upwards and if possible all-
over the ground. But the relieving has to be positioned so that the jack
plate is at best centric in the relieving. The jack plate must absolutely be
inside the relieving. Take into consideration that you may push the jack
plate on the supporting plate during the positioning of the Steiger.
10.2.2 Cleaning and maintenance
Only use suitable solvent-free cleansing agents and care products to clean
the supporting plates. Replace damaged supporting plates.
To Next Page
Loading...
