6
JR SODCUTTER
SET-UP
SET-UP
– To prevent injury, wear eye protection and stand clear whe cutting banding. Banding is under tension and
may snap back when cut.
1. Remove crate top, sides and plastic covering unit. Remove the banding attaching the Jr. Sodcutter to the
pallet.
2. Roll the Jr. Sodcutter off the pallet. The unit can also be driven off the pallet, but rst read the Safety,
Controls, and Operation sections of this manual, then check the oil and add gas.
3. Dispose of pallet, crate, plastic and banding in a responsible manner.
To Next Page
Loading...
