Ryobi BS902 - TOOLS NEEDED; LOOSE PARTS LIST

11
TOOLS NEEDED
The following tools (not included) are needed for making adjustments or installing the blade:
Fig. 5
PHILLIPS SCREWDRIVER
COMBINATION
SQUARE
LOOSE PARTS LIST
MITER GAUGE
4 mm HEX KEY
SAW TABLE
Fig. 4
FLAT HEAD SCREW
TABLE ALIGNING
BOLT
WASHER
WING NUT
RIP FENCE
WING SCREW
WORKLIGHT
Hex Key, 4 mm .............................................................. 1
Rip Fence ...................................................................... 1
Miter Gauge ................................................................... 1
Saw Table ......................................................................
1
Wing Screw ...................................................................
1
Wing Nut ........................................................................ 1
Table Aligning Bolt ......................................................... 1
Flat Head Screw ............................................................ 3
Worklight ....................................................................... 1
Washer .......................................................................... 1
Switch Key .................................................................... 1
Operator’s Manual (not shown) ..................................... 1
SWITCH
KEY
The following items are included with the tool:
WARNING:
The use of attachments or accessories not listed might be hazardous and could cause serious personal injury.