6
SYMBOLS
Some of the following symbols may be used on this tool. Please study them and learn their meaning. Proper inter-
pretation of these symbols will allow you to operate the tool better and safer.
Read Operator’s Manual
Safety Alert
No Hands Symbol
Voltage
Current
Frequency (cycles per second)
Power
Time
Type of current
Type or a characteristic of current
Rotational speed, at no load
Double-insulated construction
Revolutions, strokes, surface speed, orbits etc., per minute
Do not expose to rain or use in damp locations.
To reduce the risk of injury, user must read and understand
operator’s manual before using this product.
Eye Protection
Always wear eye protection marked to comply with ANSI
Z87.1.
Indicates a potential personal injury hazard.
Failure to keep your hands away from the blade will result in
serious personal injury.
Wet Conditions Alert
.../min
Per Minute
Class II Construction
n
o
No Load Speed
Direct Current
Alternating Current
min Minutes
W Watt
Hz Hertz
A Amperes
V Volts
Always watch for movement paying extra attention to
potential areas where pinching could occur.
Pinch Warning
To Next Page
Loading...
