18
1
2
2
2
1
REMOVING BUTTRESS ROOTS
1. Remove large buttress roots prior to
felling. Pull the trigger release, and
squeeze the switch trigger to start the
product. Make the horizontal cut into the
buttress first, followed by the vertical cut.
2. Remove the resulting loose section
from the work area. Follow the correct
tree felling procedure after you have
removed the large buttress roots.
WARNING: Do not cut through the hinge.
2. As the felling gets close to the hinge,
the tree should begin to fall. If there is
any chance that the tree may not fall in
desired direction or it may rock back and
bind the saw chain, stop cutting before
the felling back cut is complete. Use
wedges of wood, plastic or aluminium to
open the cut and drop the tree along the
desired line of fall.
To Next Page
Loading...
Need help?
General
