TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Bar and chain running hot and
smoking.
Chain lubricant tank empty. Lubricant tank should be filled every time fuel
tank is filled.
Chain tension is too tight. Tension chain per instructions in Adjusting the
Chain Tension in the Maintenance section of
this manual.
Oiler is not functioning. Run at half throttle 30 to 45 seconds. Stop
saw and check for lubricant dripping from
guide bar. If lubricant is present, the chain
may be dull or bar may be damaged. If no
lubricant is present contact an authorised
service centre.
Engine starts and runs, but
chain is not rotating.
Chain brake is engaged. Release chain brake. Refer to Operating the
Chain Brake in the Operation section of this
manual.
Chain tension is too tight. Tension chain per instructions in Adjusting the
Chain Tension in the Maintenance section of
this manual.
Guide bar and chain
assembled incorrectly.
Refer to Replacing the Guide Bar and Chain
in the aintenance section of this manual.
Guide bar and/or chain are
damaged
Inspect guide bar and chain for damage.
Drive sprocket teeth damaged Contact an authorised service centre for drive
To Next Page
Loading...
Need help?
General
