Ryobi RLT254CDSO - Product Maintenance and Storage; Cleaning the Product

37
OPERATION
1
1
4
2
3
3
4
2
1
23.5Nm
3
4
REPLACING THE SPARK PLUG
1. Turn off the product
2. Press the snap of protect cap
3. Pull away the protect cap from the
housing.
Twist the metal spark plug boot and pull it
away from the spark plug.
Loosen the spark plug by turning it in
a counterclockwise direction using a
combination wrench.
Remove the old spark plug and replace with
a new one.
4. Tighten by turning it in a clockwise
direction or one half of a turn from finger
tight using a combination wrench.
Assemble back the metal spark plug boot
and the plastic protect cap.
2