SYMBOLS ON THE PRODUCT
Safety alert
Regulatory Compliance Mark
(RCM). Product meets applicable
regulatory requirements.
Please read the instructions
carefully before starting the
machine.
Wear ear protection
Always wear eye protection.
Class II tool, double insulation
Keep hands away from the cutting
area and sharp blade.
Do not expose to rain or use in
damp locations.
Wear safety gloves
Blade rotation direction (shown on
saw blade)
Blade rotation direction (shown
on blade guard)
Blade width of cut (Kerf)
Number of teeth on this saw blade
Cutting capacity
For cutting wood and analogous
material
Not for cutting metals
LASER
2
Laser radiation.
Do not stare into beam.
Class 2 laser product
Do not stare into beam.
Laser radiation.
Class 2 laser product
λ: 650nm; P≤1mW
IEC 60825-1:2014
2
1
Adjust the position of sliding
fence before performing bevel
cuts.
Waste electrical products should
not be disposed of with household
waste. Please recycle where
facilities exist. Check with your
Local Authority or retailer for
recycling advice.
SYMBOLS IN THIS MANUAL
Connect to power outlet.
Disconnect from power outlet.
Lock
Unlock
Parts or accessories sold separately
Note
Warning
The following signal words and meanings are intended to
explain the levels of risk associated with this product:
DANGER
Indicates an imminently hazardous situation, which, if not
avoided, will result in death or serious injury.
WARNING
Indicates a potentially hazardous situation, which, if not
avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation, which, if not
avoided, may result in minor or moderate injury.
CAUTION
(Without Safety Alert Symbol) Indicates a situation that may
result in property damage.
6
To Next Page
Loading...
