Ryobi RPP254FEJSN - Operation; Mixing the Fuel

9
English
To remove:
■ Loosen the knob.
■ Push in the button and twist the shafts to remove and
separate ends.
AUTOMATIC BAR AND CHAIN LUBRICATION
Add bar and chain lubricant in the bar lube reservoir before
starting the engine of the power head. Refer to Automatic
bar and chain lubrication in the Maintenance section of
this manual.
OPERATION
WARNING
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a
second is sufcient to inict serious injury.
WARNING
Always wear safety goggles or safety glasses with side
shields, a hard hat, and safety shoes when operating
power tools. Failure to do so could result in objects
being thrown into your eyes, resulting in possible
serious injury.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING
To avoid kickback, binding of the saw bar, and possible
injury, never cut limbs that the pruner does not reach
when supported by the shoulder strap.
APPLICATIONS
You may use this product for the purposes listed below:
■ Limbing
■ Pruning
FUEL AND REFUELLING
HANDLING THE FUEL SAFELY
Always handle fuel with care, it is highly ammable.
■ Always refuel outdoors where there are no sparks and
flames. Do not inhale fuel vapors.
■ Do not let petrol or oil come in contact with your skin.
■ Keep petrol and oil away from the eyes. If petrol
or oil comes in contact with the eyes, wash them
immediately with clean water. If irritation is still present,
see a doctor immediately.
■ Clean up spilled petrol immediately.
MIXING THE FUEL
■ This product is powered by a 2-stroke engine and
requires pre-mixing petrol and 2-stroke oil. Pre-mix
unleaded petrol and 2-stroke engine oil in a clean
container approved for petrol.
IMPORTANT! Failure to use two stroke oil will result in the
engine seizing. Such damage will not be covered under
warranty.
■ This engine is certified to operate on unleaded petrol
intended for automotive use with an octane rating of
91 ([R + M] / 2) or higher.
■ Do not use any type of pre-mixed petrol / oil from fuel
service stations, this includes the pre-mixed petrol / oil
intended for use in mopeds, motorcycles, etc.
■ Avoid the use of Ethanol fuels or fuels containing
Ethanol. The use of Ethanol fuels may result in
damage to your engine.
■ Use synthetic 2-stroke oil only. Do not use automotive
oil or 2-stroke outboard oil.
■ Mix 2% synthetic 2-stroke oil into the petrol. This is a
50:1 ratio.
■ Mix the fuel thoroughly and also each time before
fueling.
■ Mix in small quantities. Do not mix quantities larger
than usable in a 30 day period. Synthetic 2-stroke oil
containing a fuel stabilizer is recommended.
50:1 Petrol to Oil Mixing Chart
1 litre + 20 ml =
2 litres + 40 ml =
3 litres + 60 ml = 50: 1 (2%)
4 litres + 80 ml =
5 litres + 100 ml =