Saba LVSL4915X - Turning On the Appliance; Forgot to Add a Dish?

Turning On the Appliance
Starting a cycle wash
1� Draw out the lower and upper basket, load the dishes and
push them back�
It is commended to load the lower basket rst, then the upper
one (see the section entitled “Loading the Dishwasher” )�
2� Pour in the detergent (see the section entitled “Salt, Detergent
and Rinse Aid” )�
3� Insert the plug into the socket� The power supply is
220-240 VAC /50 HZ, the specication of the socket is
10A250VAC� Make sure that the water supply is turned
ontofull pressure�
4� Close the door, press the power button, and the power
indicator will be lighted�
5� Press the program button , the wash program will be changed
as follows direction:
ECO->Glass->1 Hour->Rapid ->Intensive->Normal;
Press the Start/Pause button, the dishwasher will start to run�
NOTE:
When you press the Start/Reset button to pause during washing,
the prog ram light will stop blinking and the dishwasher will
mooing every minute unless you press the Start/Reset button to
start�
Change the Program...
Premise:
1� A cycle that is underway can only be modied if it has only
been running for a short time� Otherwise, the detergent may
have already been released, and the appliance may have
already drained the wash water�
If this is the case, the detergent dispenser must be relled
(seethe section entitled “Loading the Detergent”)�
2�
,
the
machine will be in standby state,
program to the desired cycle setting
“Starting a wash cycle� ��”)�
NOTE: During delaying state, press the start/reset button, then
you can change the program and delay time�
NOTE:
If you open the door during a wash cycle, the machine will pause�
The program light will stop blinking and the buzzer will mooing
every minute unless you close the door� After you close the door,
the machine will keep on working after 10 seconds�
Forgot to Add a Dish?
A forgotten dish can be added any time before the detergent cup
opens�
1� Press the start/reset button
2� Open the door a little to stop the washing�
3� After the spray arms stop working, you can open the door
completely�
9594
GB GB
Press the Start/Pause button, then press the program button
more than 3 seconds
then you can change the
(see the section entitled