EasyManua.ls Logo

Saba OMP7324BL/A - Page 47

Saba OMP7324BL/A
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GB GB
91
90
mode starts, touch “switch knob ” key can pause the function.
After the self-cleaning function is confirmed and started, clock
position shows working countdown time, temperature position
shows “PYR”. Oven lamp cannot be used after pyrolytic
self-cleaning mode is activated.
After self-cleaning process starts, if the display screen shows
fault code “E-3”, please refer to protection function for problem
analysis(protect function 10.5). You can long press switch knob or
K2 button “ ” to cancel the fault code and return to standby
mode. After clear the fault code, reset self-cleaning function, and
press switch knob again to start.
The reservation function is not allowed when the oven under
the pyrolytic self-cleaning function.
7. Door lock function
7.1 When the oven is in the reservation state or works with the
self-cleaning function, the oven door lock function is activated
and the oven is locked.
7.2 Door lock display: When self-cleaning process is completed,
oven will enter standby mode. When oven cavity temperature is
higher than 300C,display screen will display door lock icon
”(display effect refer to picture10.) Door lock will be relieved
automatically when cavity temperature is lower than 280C, door
lock icon “ ” on the display screen will extinguish at this time.
(Refer to picture11 for display effect.)
7.3 Door lock is activated: oven will be locked under following
status:
Among all function mode(except for defrost mode),door lock
will automatically be activated when oven cavity temperature is
higher than 300C.
During self-cleaning process, door lock will be activated.
When oven is under standby mode, and temperature sensor is
open-circuit or short circuit, door lock will be activated and cooling
fan still works, display effect will be as picture10 shown.
The oven door lock is locked when the oven uses the reservation
function
7.4 Door lock is relieved: oven will be unlocked meeting the
following requirements:
When self-cleaning process is completed or paused, oven door
lock will automatically be relieved only when oven cavity
temperature drops to below 280C. If electricity is cut off during
“ ”(display effect refer to picture10.) Door lock will be relieved
lock icon “ ” on the display screen will extinguish at this time.
Pic 10:Door lock activated display effect
Pic 11: Door lock activated display effect

Related product manuals