Sachs 200 - 22.6. Install the carrier plate assembly (5-160) and position it to match the witness marks made in para. 12.3.; 22.7. Secure the carrier plate with 3 bolts. The top bolt and the lower right bolt have split lockwashers. The lower left bolt does not have one. Be sure the stop bracket (5-154) and thestop lever (5-155) are properly installed.; 22.8. Put the small loose gear (4-142) on the mainshaft with bushing (4-143), thrust washer (4-142 a) and additional washer (Figure 14 item E) if needed.; 22.9. On the magneto half of the crankcase, insert 13 rollers (2-59), mainshaft output shim (4-144) (Figure 14, item F) on the output end of the mainshaft. This assembly will be installed as a unit.