Sachs 200 - 32.9 Put a new gasket (1-14) on the crankcase studs.; 32.10 With the piston rings on the piston, the cylinder can be put on. Place wooden sticks under the piston to keep it from moving and place the cylinder on the top piston ring. Carefully push the top ring into the groove and work around until the entire ring is in the groove. DO NOT BREAK THE SECOND RING. The cylinder is heavy and as the first ring snaps into place, the cylinder will drop onto the second ring and may break it.; 32.11. With all three rings up in the cylinder, bolt the cylinder to the crankcase.; 33. CYLINDER HEAD