Sachs SA 280A - Ing Direction

Fi g. 42
Before inserting pulley, sti ck disc
(3 , Fig. 41) 0.8 mm thick (0 .032 in.)
with a little
grease into recess of
pulley.
Fit pulley on to bearing bolt and
insert end of spring (4, Fig. 41) at
stud (1).
Tension pulley/coil spring in di-
rection
of cord exit until st op is
encounte r ed .
Rel ease coil spring approx . 'h
... 1 turn until the recess for the
F& s<.oJ ,,n so ld er ing nipple in the pulley
rests
nea r the cord duct of the
Fig . 42 housing.
Again hold
the pulley fi rm ly with home-made r etaining clip (1, Fig. 43).
Pull
th e starier cord through a rag soaked wi th SAE 10 oil befor e assembling.
F8 S 40 ? 1:3t..
Fi g. 43
F &Sl.. 07 l : J3
Fi g. 44
Fi
g. 43
Nate:
Wh en converting sta rting direc-
tion, reposition cord
gu i de ( 2)
also .
Fit sta rt er h andle with st op and
clamping ring on to cord .
Lay
starter cord around clamp -
ing
taper and pull it in to cl amp -
in g ring.
Pull clamping ring into starter
handl e an d let start er cord run
bock.
Fi g . 44
S crew labyrinth ring (2) tight.
Lubricate s
tart er paw l bed and
sta rter pawls li ghtly with SAE 10
o
il.
Fit sta rter pawls {1 a nd 4).
Th e open si de of the star t er
pawl seati ng and the long side
of the starter
pawl face in sta rt-
ing
dir ection.
Fit
wa sh er 0.1 mm (0.0039 in .)
thick, friction pl
at e (3), spring
ring a nd shims as required.
Insert
brake sp ring (5).
After mounting the brak e spring, the friction plate should have an ax ial pl ay of
0.1 ...
0.2 mm (0 .00 39 ... 0.0079 in .).
Correct this pl
ay by putting shims und er th e brak e s pr in g.
26